Exhaust

Simons Axle-Back Systems

Simons Axle-Back Systems guide

Simons’ listings in this category are rear silencers: the last box and its tailpipes, joined to the car’s existing pipework in front of them. The material is stated for each, mostly stainless steel, and some are Duplex rear silencers with twin pipes.

The specification table is where they differ. It gives the tailpipe layout, from a single pipe that can exit left or right to twin pipes, and the diameter of the pipe the silencer joins, split into twin inlets on some. Match the inlet to the pipe it will join, and check the tailpipe position against the cut-out in your bumper before ordering.

The table also states the type approval. Several silencers carry EC type approval with its E-number, while others state that they have none, so read that line if your car is inspected on the road.

When fitting, use a new clamp or gasket at the joint, and hang the silencer on rubber mounts in good condition so it cannot knock against the floor pan.