Fuel System

AN Hose & PTFE Line

Top brands in AN Hose & PTFE Line

AN Hose & PTFE Line guide

Braided AN hose is the flexible line for fuel, oil and brake circuits on performance and competition cars, sized by the same dash numbers as its fittings. This category holds PTFE-lined hose with stainless braid, nylon-braided hose with a reinforced CPE core, pre-cut and made-up lengths, PTFE hose ends and line stays.

The liner decides what the hose can carry. PTFE is chemically inert, so it tolerates every common fuel, including high-ethanol blends and methanol, and lets almost no vapour through. A rubber core such as CPE is more flexible and takes simpler ends, but vapour slowly permeates it, and its alcohol resistance depends on the compound.

PTFE is stiffer, with a larger minimum bend radius, and its liner kinks if bent too tightly or crushed. It needs dedicated ends that clamp the liner with an olive. In brake lines, PTFE swells less under pressure than rubber, which keeps the pedal firm.

Compare bores, not just dash sizes:

  • PTFE fuel and oil hose: AN6 (8.13 mm), AN8 (10.67 mm) and AN10 (12.95 mm). Some sizes also come with a clear or black coating over the braid.
  • PTFE brake hose: AN3 (3.56 mm) and AN4 (4.83 mm), with the same coatings; road use may need approved assemblies, depending on the country.
  • Nylon-braided CPE hose: AN4 (5.5 mm) to AN20 (28.5 mm), including AN6 at 8.7 mm against 8.13 mm for PTFE. Its core has embedded stainless reinforcement, and nylon braid is kinder to neighbouring parts than steel.
  • Lengths and assemblies: AN6 and AN10 hose with stainless or black nylon braid in lengths stated in feet, and AN10 assemblies with straight and 90° ends.
  • Ends and stays: forged 90° PTFE ends in AN6 and AN8, a straight AN8, and AN10 line stays in black or gold. Oil line kits for particular models are listed by car.

Cut PTFE hose square through a wrap of tape, using a sharp blade or cut-off wheel. Slide the nut on first, fit the olive between liner and braid, and seat the liner fully on the nipple, or it will leak or blow off. Ordinary reusable ends suit rubber-cored hose only, never PTFE.

Route hose in gentle bends, clear of exhaust heat and sharp edges, and clip it so it cannot rub. Bare steel braid can saw through wiring and softer hoses, which stays and coatings help prevent. Replace any length with broken braid wires, kinks, weeping ends or a hardened feel.