
Engine Management
Wideband Controllers
- 7 products
- 2 brands
- Ships from EU stock
- Wideband Controllers guide
Top brands in Wideband Controllers
Wideband Controllers guide
A wideband controller runs a wideband oxygen sensor and turns its signal into an air/fuel ratio reading for the ECU, a gauge or a data logger. This page holds Haltech’s CAN wideband controller kits in single- and dual-channel versions, for Bosch or NTK sensors, and Innovate’s wideband controller kits with a sensor cable, some with the sensor and a weld-in bung.
A wideband sensor needs a controller because its element must be heated to a set temperature and its pumping current regulated all the time. Without that control it reads wrongly, and a sensor left in the exhaust without power is soon fouled by soot. A controller does both jobs and reports the mixture across the whole working range, rich to lean, where a narrowband sensor only shows which side of the ideal mixture the engine is on.
How to choose:
- Output: a CAN controller sends the reading over the network to an ECU or dash that can read it, while an analogue output suits ECUs and gauges with a spare voltage input.
- Channels: a dual-channel controller reads two sensors, one for each bank of a V engine.
- Sensor: each kit is made for one sensor type, named in the title, so a replacement sensor must be the same type.
- Kit contents: some kits include the sensor and a bung, others only the controller and cable, for a car that already has a sensor fitted.
Fit the bung on top of the pipe, ahead of any catalyst and well clear of the exhaust ports, so the sensor sits above horizontal and condensation runs away from it. Power the controller from a switched supply that comes on with the ignition, and let the sensor warm up before trusting the reading. Wideband gauges are listed under Gauges & Sensors › Air/Fuel Ratio Gauges.









