Front Bumperlip Spoon PU (Civic 91-96 2/3dr)

Description

– Excellent fitment
– Made from PU material

Aerodynamics is specialized in the production of high-quality automotive bodyparts, varying from ABS, Polyester, Carbon Fibre and Aluminium materials.
All products are tested on fitments to ensure quality of the complete range of Aerodynamics bodystyling and -tuning components.

Installation

Our Polyurethane and Plastic parts are a good fit but sometimes require a
different fitting technique than Fiberglass parts. DO NOT PAINT LIP
BEFORE INSTALLATION. Best tools for the job are Tiger Seal or 3M tape,
hair dryer or heat gun and self-tapping screws. Polyurethane is rubber,
it can be flexible or brittle depending on the temperatures, in warm
weather they are usually more flexible than in the winter but you may
need to warm it up gently with a hair dryer or heat gun to get it to
flex in difficult areas such as around wheel arches. Easiest way to fit
bumper lips is by taking the bumper off as the bumper will flex making
it easier to install the lip and wrap it around the bumper, we advise
you mask the area where the lip is being fitted to avoid scratching.
Once the lip is in place screw the rear of the lip where it wraps around
the wheel arch. Also doesn’t do any harm putting some screws in the
underside. For the front you can either use 3M tape or Tiger seal, This
will then need either clamping in place to set or screwing in place –
leave over night to set. Keep in mind, no lip is ever 100% perfect.
However, once you are at the stage above a bodyshop can fill the small
gaps, fill the screw holes if required and then prime and paint.

We are all different, and some people leave them as they are in bare
form and happy with it, some rather have them painted, it’s all about
your choices.