Aerodynamics – Bumperlip Front ”Mugen” (CR-Z 2010-2013)

Description

Specifications:

Specifications:
More Information

• Manufacturer Aerodynamics
• Materials ABS
• Installation Our Polyurethane and Plastic parts are a good fit but sometimes require a different fitting technique than Fiberglass parts. DO NOT PAINT LIP BEFORE INSTALLATION. Best tools for the job are Tiger Seal or 3M tape, hair dryer or heat gun and self-tapping screws. Polyurethane is rubber, it can be flexible or brittle depending on the temperatures, in warm weather they are usually more flexible than in the winter but you may need to warm it up gently with a hair dryer or heat gun to get it to flex in difficult areas such as around wheel arches. Easiest way to fit bumper lips is by taking the bumper off as the bumper will flex making it easier to install the lip and wrap it around the bumper, we advise you mask the area where the lip is being fitted to avoid scratching. Once the lip is in place screw the rear of the lip where it wraps around the wheel arch. Also doesn't do any harm putting some screws in the underside. For the front you can either use 3M tape or Tiger seal, This will then need either clamping in place to set or screwing in place – leave over night to set. Keep in mind, no lip is ever 100% perfect. However, once you are at the stage above a bodyshop can fill the small gaps, fill the screw holes if required and then prime and paint. We are all different, and some people leave them as they are in bare form and happy with it, some rather have them painted, it’s all about your choices.